AudioCodes Mediant 500 MSBR, Руководство пользователя

Страница: 1207 / 1248

Version 7.2 1207 Mediant 500 MSBR
User's Manual 74. Configuration Parameters Reference
GW Max Call Duration
configure voip > sip-
definition settings > gw-
mx-call-duration
[GWMaxCallDuration]
Defines the maximum duration (in minutes) per Gateway call. If this
duration is reached, the device terminates the call. This feature is useful
for ensuring available resources for new calls, by ensuring calls are
properly terminated.
The valid range is 0 to 35,791, where 0 is unlimited duration. The
default is 0.
Note: The parameter is applicable only to the Gateway application.
configure voip > sip-
definition settings > mn-
call-duration
[MinCallDuration]
Defines the minimum call duration (in seconds) for the Tel side. If an
established call is terminated by the IP side before this duration expires,
the device terminates the call with the IP side, but delays the
termination toward the Tel side until this timeout expires.
The valid value range is 0 to 10 seconds, where 0 (default) disables this
feature.
For example: assume the minimum call duration is set to 10 seconds
and an IP phone hangs up a call established with a BRI phone after 2
seconds. As the call duration is less than the minimum call duration, the
device does not disconnect the call on the Tel side. However, it sends a
SIP 200 OK immediately upon receipt of the BYE to disconnect from the
IP phone. The call is disconnected from the Tel side only when the call
duration is greater than or equal to the minimum call duration.
Note:

The parameter is applicable only to the Gateway application.

The parameter is applicable to IP-to-Tel and Tel-to-IP calls.

The parameter is applicable only to ISDN and CAS protocols.
Disconnect on Dial Tone
configure voip > gateway
analog fxo-setting > disc-
on-dial-tone
[DisconnectOnDialTone]
Determines whether the device disconnects a call when a dial tone is
detected from the PBX.

[0] Disable = (Default) Call is not released.

[1] Enable = Call is released if a dial tone is detected on the device's
FXO port.
Note:

The parameter is applicable only to FXO interfaces.

This option is in addition to the mechanism that disconnects a call
when either busy or reorder tones are detected.
Send Digit Pattern on
Connect
configure voip > sip-
definition settings > digit-
pttrn-on-conn
[TelConnectCode]
Defines a digit pattern to send to the Tel side after a SIP 200 OK is
received from the IP side. The digit pattern is a user-defined DTMF
sequence that is used to indicate an answer signal (e.g., for billing).
The valid range is 1 to 8 characters.
Note: The parameter is applicable only to FXO and CAS.
Broken Connection
Mode
configure voip > sip-
definition settings > disc-
broken-conn
[DisconnectOnBrokenCo
nnection]
Global parameter that defines the device's handling of calls if RTP
packets are not received within a user-defined timeout (configured by
the BrokenConnectionEventTimeout parameter). You can also
configure this feature per specific calls, using IP Profiles
(IpProfile_DisconnectOnBrokenConnection). For a detailed description
of the parameter and for configuring this feature in the IP Profiles table,
see Configuring IP Profiles on page 404.
Note: If this feature is configured for a specific IP Profile, the settings of
this global parameter is ignored for calls associated with the IP Profile.