AudioCodes Mediant 500 MSBR, Руководство пользователя

Страница: 873 / 1248

Version 7.2 873 Mediant 500 MSBR
User's Manual 58. Viewing VoIP Status
End Point Displays the device's endpoint involved in the call, displayed in the
format:

Analog: <interface>-<module>/<port>. For example, "FXS-3/1"
denotes FXS module 3, port 1.

Digital: <interface>-<module>/<Trunk ID>/<B-channel>. For
example, "ISDN-1/2/3" denotes ISDN module 1, Trunk ID 2, B-
channel 3.
Caller Displays the phone number (source number) of the party who made
the call.
Callee Displays the phone number (destination number) of the party to whom
the call was made.
Direction Displays the direction of the call with regards to IP and Tel sides:

"Incoming": IP-to-Tel call

"Outgoing": Tel-to-IP call
Remote IP Displays the IP address of the call party. For an "Incoming" call, this is
the source IP address; for an "Outgoing" call, this is the destination IP
address.
Duration Displays the duration of the call, displayed in the format hh:mm:ss,
where
hh is hours, mm minutes and ss seconds. For example,
00:01:20 denotes 1 minute and 20 seconds.
Termination Reason Displays the reason for the call being released (ended). For example,
"NORMAL_CALL_CLEAR" indicates a normal off-hook (hang up) of the
call party.
Session ID Displays the SIP session ID of the call.
58.7 Viewing SBC CDR History
You can view historical Call Detail Records (CDR) of SBC calls in a table. History CDRs
are stored on the device’s memory. When a new CDR is generated, the device adds it to
the top of the table and all existing entries are shifted one down in the table. The table
displays the last 4,096 CDRs. If the table reaches maximum capacity of entries and a new
CDR is added, the last CDR entry is removed from the table.
Note: If the device is reset, all CDRs are deleted from memory and from the table.

To view SBC CDR history:

Web: Open the SBC CDR History table ( Monitor menu > Monitor tab > VoIP Status
folder > SBC CDR History ).
Figure 58-6: SBC CDR History Table

CLI: