AudioCodes Mediant 500 MSBR, Руководство пользователя

Страница: 490 / 1248

User's Manual 490 Document #: LTRT-10375
Mediant 500 MSBR
Parameter Description
group). When a call is received for the Trunk Group, all
telephones connected to the FXS ports belonging to the Trunk
Group start ringing. The call is eventually received by whichever
telephone first answers the call (after which the other phones stop
ringing). This option is applicable only to FXS interfaces.

[10] Select Trunk by Supp-Serv Table = The BRI port/module is
selected according to the settings in the Supplementary Services
table (see Configuring Multi-Line Extensions and Supplementary
Services on page 587), allowing the routing of IP-to-Tel calls to
specific BRI endpoints according to extension number. This option
is applicable only to FXS and BRI interfaces.

[11] By Dest Number & Ascending = The device allocates a
channels to incoming IP-to-Tel calls as follows:
a. The device attempts to route the call to the channel that is
associated with the destination (called) number. If located, the
call is sent to that channel.
b. If the number is not located or the channel is unavailable
(e.g., busy), the device searches in ascending order for the
next available channel in the Trunk Group. If located, the call
is sent to that channel.
c. If all the channels are unavailable, the call is released.
Note: If the parameter is not configured, the Trunk Group's channel
select method is according to the global parameter,
ChannelSelectMode.
Registration Mode
registration-mode
[TrunkGroupSettings_Regi
strationMode]
Defines the registration method of the Trunk Group.

[0] Per Endpoint = Each channel in the Trunk Group registers
individually. The registrations are sent to the 'Serving IP Group ID'
if configured in the table; otherwise, it is sent to the default Proxy,
and if no default Proxy, then to the Registrar IP.

[1] Per Gateway = (Default) Single registration for the entire
device. This is applicable only if a default Proxy or Registrar IP is
configured and Registration is enabled (i.e., parameter
IsRegisterUsed is set to 1). In this mode, the SIP URI user part in
the From, To, and Contact headers is set to the value of the
global registration parameter, GWRegistrationName or username
if GWRegistrationName is not configured.

[4] Don't Register = No registrations are sent by endpoints
pertaining to the Trunk Group. For example, if the device is
configured globally to register all its endpoints (using the
parameter ChannelSelectMode), you can exclude some endpoints
from being registered by assigning them to a Trunk Group and
configuring the Trunk Group registration mode to 'Don't Register'.

[5] Per Account = Registrations are sent (or not) to an IP Group
according to the settings in the Accounts table (see Configuring
Registration Accounts on page 363).
An example is shown below of a REGISTER message for registering
endpoint "101" using the registration Per Endpoint mode:
REGISTER sip:SipGroupName SIP/2.0
Via: SIP/2.0/UDP
10.33.37.78;branch=z9hG4bKac862428454
From: <sip:101@GatewayName>;tag=1c862422082
To: <sip:101@GatewayName>
Call-ID: 9907977062512000232825@10.33.37.78
CSeq: 3 REGISTER