AudioCodes Mediant 500 MSBR, Руководство пользователя

Страница: 1169 / 1248

Version 7.2 1169 Mediant 500 MSBR
User's Manual 74. Configuration Parameters Reference

[0] = Disable (default)

[1] = Enable
Note: The parameter is applicable only to FXO interfaces.
Hotline Dial Tone Duration
configure voip > gateway dtmf-
supp-service dtmf-and-dialing
> hotline-dt-dur
[HotLineToneDuration]
Defines the duration (in seconds) of the hotline dial tone. If no
digits are received during this duration, the device initiates a call
to a user-defined number (configured in the Automatic Dialing
table - TargetOfChannel - see Configuring Automatic Dialing on
page 603).
The valid range is 0 to 60. The default is 16.
Note:

The parameter is applicable only to analog interfaces.

You can define the Hotline duration per FXS/FXO port using
the Automatic Dialing table.
Reorder Tone Duration
configure voip > gateway
analog fxo-setting > reorder-
tone-duration
[TimeForReorderTone]
Global parameter defining the duration (in seconds) that the
device plays a busy or reorder tone before releasing the line.
You can also configure the feature per specific calls, using Tel
Profiles (TelProfile_TimeForReorderTone). For a detailed
description of the parameter and for configuring the feature in the
Tel Profiles table, see Configuring Tel Profiles on page 440.
Note: If the feature is configured for a specific Tel Profile, the
settings of the global parameter is ignored for calls associated
with the Tel Profile.
Time Before Reorder Tone
time-b4-reordr-tn
[TimeBeforeReorderTone]
Defines the delay interval (in seconds) from when the device
receives a SIP BYE message (i.e., remote party terminates call)
until the device starts playing a reorder tone to the FXS phone.
The valid range is 0 to 60. The default is 0.
Note: The parameter is applicable only to FXS interfaces.
Cut Through Reorder Tone
Duration
cut-thru-reord-dur
[CutThroughTimeForReOrderT
one]
Defines the duration (in seconds) of the reorder tone played to the
Tel side after the IP call party releases the call, for the Cut-
Through feature. After the tone stops playing, an incoming call is
immediately answered if:

For analog interfaces: The FXS is off-hooked

For digital interfaces: The PSTN is connected
The valid values are 0 to 30. The default is 0 (i.e., no reorder tone
is played).
Note: To enable the Cut-Through feature, use the
DigitalCutThrough (for CAS channels) or CutThrough (for FXS
channels) parameter.
Enable Comfort Tone
comfort-tone
[EnableComfortTone]
Determines whether the device plays a comfort tone (Tone Type
#18) to the FXS/FXO endpoint after a SIP INVITE is sent and
before a SIP 18x response is received.

[0] Disable (default)

[1] Enable
Note: The parameter is applicable to FXS and FXO interfaces.
[WarningToneDuration] Defines the duration (in seconds) for which the offhook warning
tone is played to the user.
The valid range is -1 to 2,147,483,647. The default is 600.
Note:

A negative value indicates that the tone is played infinitely.