AudioCodes Mediant 500 MSBR, Руководство пользователя

Страница: 682 / 1248

User's Manual 682 Document #: LTRT-10375
Mediant 500 MSBR
SIP Interface can be one that is associated with any SRD or Routing
Policy (but it's recommended that it belong to the same SRD/Routing
Policy or to shared SRD/Routing Policy to avoid "bleeding").
Destination Address
dst-address
[IP2IPRouting_DestAddre
ss]
Defines the destination address to where the call is sent. The address
can be an IP address or a domain name (e.g., domain.com).
If ENUM-based routing is used (i.e., the 'Destination Type' parameter is
set to
ENUM ) the parameter defines the IP address or domain name
(FQDN) of the ENUM service, for example, e164.arpa,
e164.customer.net or NRENum.net. The device sends the ENUM query
containing the destination phone number to an external DNS
serverconfigured for the associated network interface. The ENUM reply
includes a SIP URI (user@host) which is used as the destination
Request-URI in this routing table.
The valid value is a string of up to 50 characters (IP address or FQDN).
By default, no value is defined.
Note:

The parameter is applicable only if the 'Destination Type' parameter
is configured to
Dest Address [1] or ENUM [3]; otherwise, the
parameter is ignored.

When using domain names, enter a DNS server IP address or
alternatively, define these names in the Internal DNS table (see
Configuring the Internal SRV Table on page 152).

To terminate SIP OPTIONS messages at the device (i.e., to handle
them locally), set the parameter to "internal".
Destination Port
dst-port
[IP2IPRouting_DestPort]
Defines the destination port to where the call is sent.
Destination Transport
Type
dst-transport-type
[IP2IPRouting_DestTrans
portType]
Defines the transport layer type for sending the call.

[-1] = (Default) Not configured - the transport type is determined by
the SIPTransportType global parameter.

[0] UDP

[1] TCP

[2] TLS
IP Group Set
ipgroupset-name
[IP2IPRouting_IPGroupSe
tName]
Assigns an IP Group Set to the routing rule. The device routes the call
to one of the IP Groups in the IP Group Set according to the load-
balancing policy configured for the IP Group Set. For more information,
see Configuring IP Group Sets on page 695.
Note: The parameter is applicable only if you configure the 'Destination
Type' parameter to IP Group Set (above).
Call Setup Rules Set ID
call-setup-rules-set-id
[IP2IPRouting_CallSetup
RulesSetId]
Assigns a Call Setup Rule Set ID to the routing rule. The device
performs the Call Setup rules of this Set ID if the incoming call matches
the characteristics of this routing rule. The device routes the call to the
destination according to the routing rule's configured action, only after it
has performed the Call Setup rules.
To configure Call Setup rules, see Configuring Call Setup Rules on
page 372.
Group Policy
group-policy
[IP2IPRouting_GroupPolic
y]
Defines whether the routing rule includes call forking.

[0] None = (Default) Call uses only this route (even if Forking Group
members are configured in the rows below it).

[1] Forking = Call uses this route and the routes of Forking Group
members, if configured (in the rows below it).