AudioCodes Mediant 500 MSBR, Руководство пользователя

Страница: 1101 / 1248

Version 7.2 1101 Mediant 500 MSBR
User's Manual 74. Configuration Parameters Reference

For ISDN interfaces, the digit map mechanism is applicable
only when ISDN overlap dialing is used (ISDNRxOverlap is set
to 1).

If the DialPlanIndex parameter is configured (to select a Dial
Plan index), then the device first attempts to locate a matching
digit pattern in the Dial Plan file, and if not found, then attempts
to locate a matching digit pattern in the Digit Map rules
configured by the DigitMapping parameter.

For more information on digit mapping, see Digit Mapping on
page 551.
Max Digits in Phone Num
configure voip > gateway dtmf-
supp-service dtmf-and-dialing
> mxdig-b4-dialing
[MaxDigits]
Defines the maximum number of collected destination number
digits that can be received (i.e., dialed) from the Tel side (analog)
or for digital, when ISDN Tel-to-IP overlap dialing is performed.
When the number of collected digits reaches this maximum, the
device uses these digits for the called destination number.
The valid range is 1 to 49. The default is 5 for analog and 30 for
digital.
Note:

Instead of using the parameter, Digit Mapping rules can be
configured.

For FXS/FXO interfaces: Dialing ends when any of the following
scenarios occur:

Maximum number of digits is dialed

Interdigit Timeout (TimeBetweenDigits) expires

Pound (#) key is pressed

Digit map pattern is matched
Inter Digit Timeout for Overlap
Dialing
configure voip > gateway dtmf-
supp-service dtmf-and-dialing
> time-btwn-dial-digs
[TimeBetweenDigits]
Analog: Defines the time (in seconds) that the device waits
between digits that are dialed by the user.
ISDN overlap dialing: Defines the time (in seconds) that the device
waits between digits that are received from the PSTN or IP during
overlap dialing.
When this inter-digit timeout expires, the device uses the collected
digits to dial the called destination number.
The valid range is 1 to 10. The default is 4.
Enable Special Digits
configure voip > gateway dtmf-
supp-service dtmf-and-dialing
> special-digits
[IsSpecialDigits]
Enables the use of the asterisk (*) and pound (#) digits in dialed
telephone numbers.

[0] Disable = Use '*' or '#' to terminate number collection (refer
to the parameter UseDigitForSpecialDTMF). (Default.)

[1] Enable = Allows '*' and '#' for telephone numbers dialed by a
user or for the endpoint telephone number.
Note:

The symbols can always be used as the first digit of a dialed
number even if you disable the parameter.

The parameter is applicable only to analog interfaces.
74.10.4 Voice Mail Parameters
The voice mail parameters are described in the table below. For more information on the
Voice Mail application, refer to the
CPE Configuration Guide for Voice Mail .