AudioCodes Mediant 500 MSBR, Руководство пользователя

Страница: 1009 / 1248

Version 7.2 1009 Mediant 500 MSBR
User's Manual 74. Configuration Parameters Reference
Start Time / Day of Month
Start
configure system > clock
> summer-time > start
[DayLightSavingTimeStart
]
Defines the date and time when DST begins. This value can be
configured using any of the following formats:

Day of year - mm:dd:hh:mm , where:

mm denotes month

dd denotes date of the month

hh denotes hour

mm denotes minutes
For example, "05:01:08:00" denotes daylight saving starting from
May 1 at 8 A.M.

Day of month - mm:day/wk:hh:mm , where:

mm denotes month (e.g., 04)

day denotes day of week (e.g., FRI)

wk denotes week of the month (e.g., 03)

hh denotes hour (e.g., 23)

mm denotes minutes (e.g., 10)
For example, "04:FRI/03:23:00" denotes Friday, the third week of
April, at 11 P.M. The week field can be 1-5, where 5 denotes the last
occurrence of the specified day in the specified month. For example,
"04:FRI/05:23:00" denotes the last Friday of April, at 11 P.M.
End Time / Day of Month
End
configure system > clock
> summer-time > end
[DayLightSavingTimeEnd]
Defines the date and time when DST ends. For a description of the
format of this value, see the DayLightSavingTimeStart parameter.
Offset
configure system > clock
> summer-time > offset
[DayLightSavingTimeOffs
et]
Defines the DST offset (in minutes).
The valid range is 0 to 120. The default is 60.
Note: The offset setting is applied only on the hour. For example, if you
configure the parameter at 15:42, the device applies the setting only at
16:00.
74.3 Debugging and Diagnostics Parameters
This subsection describes the device's debugging and diagnostic parameters.
74.3.1 General Parameters
The general debugging and diagnostic parameters are described in the table below.
Table 74-17: General Debugging and Diagnostic Parameters
Parameter Description
enablesecsyslog
[EnableSecSyslog]
Enables the reporting of security-related events for the data-router
networking. When enabled, the data-router access list rules, configured
using the access-list CLI command, which are set to "log", send Syslog
messages whenever traffic matching the access list is encountered.

[0] = (Default) Disabled

[1] = Enabled