AudioCodes Mediant 500 MSBR, Руководство пользователя

Страница: 373 / 1248

Version 7.2 373 Mediant 500 MSBR
User's Manual 21. SIP Definitions
international calls.

Manipulation (similar to the Message Manipulations table) of call parameters (such as
source number, destination number, and redirect number) and SBC SIP messages.

Conditions for routing, for example, if the source number equals a specific value, then
use the call routing rule.
You configure multiple Call Setup rules and group them using a Set ID . This lets you apply
multiple Call Setup rules on the same call setup dialog. To use your Call Setup rule(s), you
need to assign the Set ID to one of the following, using the 'Call Setup Rules Set ID' field:

SBC IP-to-IP routing rules (see Configuring SBC IP-to-IP Routing Rules on page 671)

Tel-to-IP routing rules (see Configuring Tel-to-IP Routing Rules on page 495)

IP-to-Tel routing rules (see Configuring IP-to-Tel Routing Rules on page 504)

IP Groups (see Configuring IP Groups on page 333)
If assigned to an IP Group, the device processes the Call Setup rule for the classified
source IP Group immediately before the routing process. If assigned to a routing rule only,
the device first locates a matching routing rule for the incoming call, processes the
assigned Call Setup Rules Set ID, and then routes the call according to the destination
configured for the routing rule. The device uses the routing rule to route the call depending
on the result of the Call Setup Rules Set ID:

Rule's condition is met: The device performs the rule's action and then runs the next
rule in the Set ID until the last rule or until a rule with an Exit Action Type. If the Exit
rule is configured with a "True" Action Value, the device uses the current routing rule.
If the
Exit rule is configured with a "False" Action Value, the device moves to the next
routing rule. If an Exit Action Type is not configured and the device has run all the
rules in the Set ID, the default Action Value of the Set ID is "True" (i.e., use the current
routing rule).

Rule's condition is not met: The device runs the next rule in the Set ID. When the
device reaches the end of the Set ID and no Exit was performed, the Set ID ends with
a "True" result.
You can also configure a Call Setup rule that determines whether the device must
discontinue with the Call Setup Rules Set ID and route the call accordingly. This is done
using the
Exit optional value of the ‘Action Type’ parameter. When used, the ‘Action Value’
parameter can be configured to one of the following strings:

“true”: Indicates that if the condition is met, the device routes the call according to the
selected routing rule. Note that if the condition is not met, the device also uses the
selected routing rule, unless the next Call Setup rule in the Set ID has an
Exit option
configured to “false” for an empty condition.

“false”: Indicates that if the condition is met, the device attempts to route the call to the
next matching routing rule (if configured). If the condition is not met, the device routes
the call according to the selected routing rule.
As the default result of a Call Setup rule is always “true”, please adhere to the following
guidelines when configuring the ‘Action Type’ field to
Exit : If, for example, you want to exit
the Call Setup Rule Set ID with "true" when LDAP query result is found and "false" when
LDAP query result is not found:

Incorrect -this rule will always exit with result = True:
Condition: ldap.found exists Action Type: Exit Action Value: True

Correct:
•
Single rule:
Condition: ldap.found !exists Action Type: Exit Action Value: False
•
Set of rules:
Condition: ldap.found exists Action Type: Exit Action Value: True