AudioCodes Mediant 500 MSBR, Руководство пользователя

Страница: 42 / 1248

User's Manual 42 Document #: LTRT-10375
Mediant 500 MSBR
a. Configure the pool of IP addresses:
(conf-if-VLAN 1)# ip dhcp-server network 10.8.6.84 10.8.6.89
255.255.255.0
b. Enable DHCP server functionality:
(conf-if-VLAN 1)# service dhcp
6. Save your settings with a flash burn:
(conf-if-VLAN 1)# do write
4.3 Configuring the WAN Interface
This procedure describes how to configure the WAN interface and uses Gigabit Ethernet
as an example. If you are using a different WAN interface, refer to the
CLI Reference
Guide .
Note: Before you configure the WAN interface, make sure that you have all the
required information from your Internet Telephony Service Provider (ITSP).

To configure a WAN IP address:
1. Connect the WAN port to the WAN network. For information on cabling the WAN port,
refer to the
Hardware Installation Manual .
2. Establish serial communication with the device.
3. At the prompt, type the following command to access the router configuration mode:
# configure data
4. Access the WAN interface:
(config-data)# interface GigabitEthernet 0/0
5. Configure the IP address and subnet mask:
(config-if-GE 0/0)# ip address 100.33.2.105 255.255.255.0
6. Enable the WAN interface:
(config-if-GE 0/0)# no shutdown
7. Exit the interface:
(config-if-GE 0/0)# exit
8. Configure the default route:
(config-data)# ip route 0.0.0.0 0.0.0.0 100.33.2.106
GigabitEthernet 0/0
9. Exit the router configuration mode:
(config-data)# exit
10. Save the configuration to flash:
# write