AudioCodes Mediant 500 MSBR, Руководство пользователя

Страница: 1130 / 1248

User's Manual 1130 Document #: LTRT-10375
Mediant 500 MSBR
cut-through-anable
[DigitalCutThrough]
Global parameter enabling PSTN CAS channels/endpoints to receive
incoming IP calls even if the B-channels are in off-hook state.
You can also configure the feature per specific calls, using Tel Profiles
(TelProfile_DigitalCutThrough). For a detailed description of the
parameter and for configuring the feature in the Tel Profiles table, see
Configuring Tel Profiles on page 440.
Note:

If the feature is configured for a specific Tel Profile, the settings of the
global parameter is ignored for calls associated with the Tel Profile.

The parameter is applicable only to digital interfaces.
74.10.5.11 Automatic Dialing Parameters
The automatic dialing upon off-hook parameters are described in the table below.
Table 74-53: Automatic Dialing Parameters
Parameter Description
Automatic Dialing Table
Automatic Dialing Table
configure voip >
gateway analog
automatic-dialing
[TargetOfChannel]
Defines telephone numbers that are automatically dialed when a specific
FXS or FXO port is off-hooked. The format of the ini file table parameter is
as follows:
[TargetOfChannel]
FORMAT TargetOfChannel_Index = TargetOfChannel_Destination,
TargetOfChannel_Type, TargetOfChannel_Module,
TargetOfChannel_Port, TargetOfChannel_HotLineToneDuration;
[\TargetOfChannel]
For example, the below configuration defines automatic dialing of phone
number 911 when the phone connected to Port 1 of Module 1 is off-
hooked for over 10 seconds:
TargetOfChannel 0 = 911, 1, 1, 1,10;
Note:

The first index of this table ini file parameter is 0.

TargetOfChannel_Module is the module number, where 1 denotes the
module in Slot 1.

TargetOfChannel_Port is the port number, where 1 denotes Port 1 on
the module.

This is parameter is applicable only to FXS and FXO interfaces.

For more information, see Configuring Automatic Dialing on page 603.
74.10.5.12 Direct Inward Dialing Parameters
The Direct Inward Dialing (DID) parameters are described in the table below.
Table 74-54: DID Parameters
Parameter Description