AudioCodes Mediant 500 MSBR, Руководство пользователя

Страница: 1104 / 1248

User's Manual 1104 Document #: LTRT-10375
Mediant 500 MSBR
PBX. The device performs a CAS wink, waits a user-defined
time (configured by the WaitForDialTime parameter), and then
dials the Refer-To number. The device completes the call
transfer by releasing the line only after detection of the
transferred party answer. To enable answer supervision, you
also need to do the following:
1) Enable voice detection (i.e., set the EnableVoiceDetection
parameter to 1).
2) Set the EnableDSPIPMDetectors parameter to 1.
3) Install the IPMDetector DSP option Feature License Key.
SMDI Parameters
Enable SMDI
configure voip > gateway
voice-mail-setting >
enable-smdi
[SMDI]
Enables Simplified Message Desk Interface (SMDI) interface on the
device.

[0] Disable = (Default) Normal serial

[1] Enable (Bellcore)

[2] Ericsson MD-110

[3] NEC (ICS)
Note:

For the parameter to take effect, a device reset is required.

When the RS-232 connection is used for SMDI messages (Serial
SMDI), it cannot be used for other applications, for example, to
access the Command Line Interface (CLI).
SMDI Timeout
configure voip > gateway
voice-mail-setting > smdi-
timeout-[msec]
[SMDITimeOut]
Defines the time (in msec) that the device waits for an SMDI Call
Status message before or after a Setup message is received. The
parameter synchronizes the SMDI and analog CAS interfaces.
If the timeout expires and only an SMDI message is received, the
SMDI message is dropped. If the timeout expires and only a Setup
message is received, the call is established.
The valid range is 0 to 10000 (i.e., 10 seconds). The default is 2000.
Message Waiting Indication (MWI) Parameters
MWI Off Digit Pattern
configure voip > gateway
voice-mail-setting > mwi-
off-dig-ptrn
[MWIOffCode]
Defines the digit code used by the device to notify the PBX that there
are no messages waiting for a specific extension. This code is added
as prefix to the dialed number.
The valid range is a 25-character string.
MWI On Digit Pattern
configure voip > gateway
voice-mail-setting > mwi-
on-dig-ptrn
[MWIOnCode]
Defines the digit code used by the device to notify the PBX of
messages waiting for a specific extension. This code is added as
prefix to the dialed number.
The valid range is a 25-character string.
MWI Suffix Pattern
configure voip > gateway
voice-mail-setting > mwi-
suffix-pattern
[MWISuffixCode]
Defines the digit code used by the device as a suffix for 'MWI On Digit
Pattern' and 'MWI Off Digit Pattern'. This suffix is added to the
generated DTMF string after the extension number.
The valid range is a 25-character string.
MWI Source Number
configure voip > gateway
voice-mail-setting > mwi-
source-number
[MWISourceNumber]
Defines the calling party's phone number used in the Q.931 MWI
Setup message to PSTN. If not configured, the channel's phone
number is used as the calling number.