AudioCodes Mediant 500 MSBR, Руководство пользователя

Страница: 55 / 1248

Version 7.2 55 Mediant 500 MSBR
User's Manual 7. Web-Based Management
click the button, the Maintenance Actions page opens, which provides commands for
doing this (see Basic Maintenance on page 759).

Typically required parameters are displayed in bold font.

If you enter an invalid value for a parameter and then click Apply , a message box
appears notifying you of the invalid value. Click OK to close the message. The
parameter reverts to its previous value and the field is surrounded by a colored border,
as shown in the figure below:

To get help on a parameter, simply hover your mouse over the parameter's field and a
pop-up help appears, displaying a brief description of the parameter.
The following procedure describes how to configure stand-alone parameters.

To configure a stand-alone parameter:
1. Modify the parameter's value as desired.
2. Click Apply ; the changes are saved to the device's volatile memory (RAM).
3. Save the changes to the device's non-volatile memory (flash):
•
If a device reset is not required:
a. On the toolbar, click Save ; a confirmation message box appears:
Figure 7-4: Save Configuration Confirmation Box
b. Click Yes to confirm; the changes are save to flash memory.
•
If a device reset is required:
a. On the toolbar, click Reset ; the Maintenance Actions page opens.
b. Click Reset ; the device saves the changes to flash memory and then resets.
Warning: When you click Apply , your changes are saved only to the device's volatile
memory and thus, revert to their previous settings if the device later undergoes a
hardware reset, a software reset (without saving to flash) or powers down. Therefore,
make sure that you save your configuration to the device's flash memory.