AudioCodes Mediant 500 MSBR, Руководство пользователя

Страница: 983 / 1248

Version 7.2 983 Mediant 500 MSBR
User's Manual 74. Configuration Parameters Reference
74 Configuration Parameters Reference
The device's VoIP functionality (not data-routing functionality) configuration parameters,
default values, and their descriptions are documented in this section.
Note: Parameters and values enclosed in square brackets [...] represent the ini file
parameters and their enumeration values.
74.1 Management Parameters
This section describes the device's management-related parameters.
74.1.1 General Parameters
The general management parameters are described in the table below.
Table 74-1: General Management Parameters
Parameter Description
WAN OAMP Interface
bind GigabitEthernet
<slot/port.vlanId> oamp
[OAMPWanInterfaceNam
e]
Binds the OAMP interface to a WAN interface, which can later be
associated with a Virtual Routing and Forwarding (VRF).
Allow WAN access to
HTTP
wan-http-allow
[AllowWanHTTP]
Enables WAN access to the management interface through HTTP.

[0] Disable (default)

[1] Enable
Note:

For the parameter to take effect, a device reset is required.

By default, the device's data-router firewall blocks all ("any")
incoming traffic on the WAN. Thus, to enable WAN access, you
must also enable the data-router firewall:
# configure data
(config-data)# interface gigabitethernet 0/0
(conf-if-GE 0/0)# firewall enable
Allow WAN access to
HTTPS
wan-https-allow
[AllowWanHTTPS]
Enables WAN access to the management interface through HTTPS.

[0] Disable (default)

[1] Enable
Note:

For the parameter to take effect, a device reset is required.

By default, the device's data-router firewall blocks all ("any")
incoming traffic on the WAN. Thus, to enable WAN access, you
must also enable the data-router firewall:
# configure data
(config-data)# interface gigabitethernet 0/0
(conf-if-GE 0/0)# firewall enable