AudioCodes Mediant 500 MSBR, Руководство пользователя

Страница: 966 / 1248

User's Manual 966 Document #: LTRT-10375
Mediant 500 MSBR
Detailed Status Displays a detailed description of the test call status:

"Idle": Test call is currently not active.

"Scheduled - Established Calls: <number of established calls>, ASR:
<ASR>%": Test call is planned to run (according to 'Schedule Interval'
parameter settings) and also shows the following summary of
completed test calls:

Total number of test calls that were established.

Number of successfully answered calls out of the total number of
calls attempted (ASR).

"Running (Calls: <number of active calls>, ASR: <ASR>%)": Test call
has been started (i.e., the
Dial command was clicked) and shows the
following:

Number of currently active test calls.

Number of successfully answered calls out of the total number of
calls attempted (Answer Success Ratio or ASR).

"Receiving (<number of active calls>)": Test call has been
automatically activated by calls received for this configured test call
endpoint from the configured remote endpoint. When all these calls
terminate, the status returns to "Idle".

"Terminating (<number of active calls>)": The Drop Call command
has been clicked to stop the test call and the test call is in the process
of terminating the currently active test calls.

"Done - Established Calls: <number of established calls>, ASR:
<ASR>%": Test call has been successfully completed (or was
prematurely stopped by clicking the
Drop Call command) and shows
the following:

Total number of test calls that were established.

Number of successfully answered calls out of the total number of
calls attempted (ASR).
MOS Status MOS count and color threshold status of local and remote sides
according to the assigned QoE Profile.
Delay Status Packet delay count and color-threshold status of local and remote sides
according to the assigned QoE Profile.
Jitter Status Jitter count and color-threshold status of local and remote sides
according to the assigned QoE Profile.
Packet Loss Status Packet loss count and color-threshold status of local and remote sides
according to the assigned QoE Profile.
Bandwidth Status Tx/Rx bandwidth and color-threshold status according to the assigned
Bandwidth Profile.
69.5 Configuring DTMF Tones for Test Calls
By default, the device plays the DTMF signal tone "3212333" to remote tested endpoints
for answered calls (incoming and outgoing). For basic test calls (as described in
Configuring Basic Test Calls on page 967), the device can play only the configured DTMF
tones (or none, if not configured). For test call endpoints that are configured in the Test Call
Rules table, you can configure the device to play either DTMF tones or a tone from an
installed PRT file (Test Call Tone). For more information, see Configuring Test Call
Endpoints on page 959.