Using via Digital Data Communication
------------------------------------------------------------------------------------
65
SCPI Command
This section explains about commands which conform to SCPI Protocol.
ADDRess Level
ADDRess level command is only for assigning the device address.
Command Name
Summary
Command Type
ADDＲess
Assigns device address
SET only
ＡDDRess
： Assigns Device Address
Function： Assigns the device address for ZX power supplies
Format：ADDRess ＜NRｆ＞
Type：SET command only
Range：０～５０
Address 0 is a global address. Assign addresses to all multi-connected ZX-S Series DC power supplies.
Once the global address is assigned, only Output ON/OFF Toggle SET command “OUTPut[：STATe]”
is valid.
Further, no Acknowledge Responses will be sent only while the global address is assigned.
＜Ex.＞
ADDR 1
Do not set redundant ZX power supply addresses within the same system.
Caution
Summary of Contents for ZX-S-H Series
