TAKASAGO ZX-S-H Series, Instruction Manual, Page: 123 / 192

Controlling with External Analog & Contact Signals
------------------------------------------------------------------------------------
119
Setting Procedures
Press the Function “ＦＵＮＣ.” key.
FUNC. lamp will light.
Settings Item Number (top) and parameters (bottom) will appear in the Number Display.
Select Item number 11 with the ＶＯＬＴＡＧＥ dial.
Change set value with the ＣＵＲＲＥＮＴ dial.
Parameter＝０;
Turns off ON/OFF Toggle at external contact (invalid).
Set if wishing to control by remote command or with the
front panel’s ON/OFF key.
Parameter＝1;
Sets Output ON if the external contact is closed.
Sets Output OFF if the external contact is opened.
Output can only be controlled by external contact points.
Power cannot be controlled by remote command (commands)
or by the front panel’s ON/OFF key.
Parameter＝2;
Allows the output to be toggled from the panel when
the external contacts are closed.
Also, sets the Output OFF if the external contact is opened.
Output can be controlled by panel or remote command when
external contacts are closed.
Sets output to OFF when contact signal is open
regardless of remote command or panel operations.
Press the ＦＵＮＣ. key again to finalize settings.
Returns the Number Display to measurement display mode.
OUTPUT
PRESET OVP OCP
FUNC.
ALARM RESET
CC
CV
OUTPUT POWER (%)
STEP
CURRENT
STEP
VOLTAGE
PRESET FUNC. REMOTE LOCK
20 60 100 LMT 40 80
CC
CV
OUTPUT POWER (%)
STEP
CURRENT
STEP
VOLTAGE
PRESET FUNC. REMOTE LOCK
20 60 100 LMT 40 80
CC
CV
OUTPUT POWER (%)
STEP
CURRENT
STEP
VOLTAGE
PRESET FUNC. REMOTE LOCK
20 60 100 LMT 40 80
CC
CV
OUTPUT POWER (%)
STEP
CURRENT
STEP
VOLTAGE
PRESET FUNC. REMOTE LOCK
20 60 100 LMT 40 80
OUTPUT
PRESET OVP OCP
FUNC.
ALARM RESET