TAKASAGO ZX-S-H Series, Instruction Manual

Page: 52 / 192

Useful Function
------------------------------------------------------------------------------------
48
Sequential Operation Function
The sequential operation function of ZX-S series is automatic sequential output control function either regularly or
continuously by setting control time for memory setting and OUTPUT OFF.
(V)/(A)
(t)
tOff tC tB tA
tA：Operating Time with Memory A
tB：Operating Time with Memory B
tC：Operating Time with Memory C
tOff：Operating Time for OUTPUT
OFF time
Sequential Operation Start
Memory
A
Memory
B
Memory
C
《Setting for Sequential Operation Function》
・ Number of repetition : Continuous Operation from 1 to 9,999 times.
・ Operating time of each memories：0-999h，0-59m，0.0-59.9sec
・ Operation time for OUTPUT OFF：0-999h，0-59m，0.0-59.9sec
Note) The accuracy of the sequential operating time is Approx. ±0.5% and settable Min.
resolution is 0.1 sec.However it may happened to have any influence against rising
and falling time of output by programming time and load conditions.and falling time
《Recordable setting for memory function》
・ CV，CC，OVP and OCP setting
・ Selection for rising mode (Setting of FUNCTION 2）
0: Priority on CV, 1: Priority on CC, 2: CV priority slew rate, and 3: CC priority slew rate
・ Rising for CV slew rate (Setting of FUNCTION 3)
・ Falling for CV slew rate (Setting of FUNCTION 4)
・ Rising for CC slew rate (Setting of FUNCTION 5)
・ Falling for CC slew rate (Setting of FUNCTION 6)
・ Internal Resister Setting (Setting of FUNCTION 72） (※) Only for ZX-S series A type
Note) Please refer to "Useful Function for Memory"in the Instruction Manual for the detail
and how to set of the Memory Function.