TAKASAGO ZX-S-H Series, Instruction Manual, Page: 97 / 192

Using via Digital Data Communication
------------------------------------------------------------------------------------
93
SYSTem：PRESet：MODE
：Sets Method to Determine PRESET Contents
Function：
Sets the method in which the PRESET contents are determined
Same
settings as FUNCTION Settings Item 50
Format：SYSTem：PRESet：MODE ＜NRｆ＞
Type：SET command, QUERY command
Parameters： 0 ・・・Changes set values after PRESET mode is completed
1 ・・・Changes set values while PRESET mode is operating
Response：Same as parameters
Restrictions： Alarm response is returned for normal SET commands in the following conditions
・While operating as a series operation slave unit
・While operating as a parallel operation slave unit
・ Sequence operation in progress
＜Ex.＞
SYST：PRES：MODE 0
SYST：PRES：MODE？
0
SYSTem：SERies
：Sets Master and Slave for Series Operation
Function： Sets the Master and Slave for Series Operation
Same settings as FUNCTION Settings Item 73
Format：SYSTem：SERies ＜NRｆ＞
Type：SET command, QUERY command
Parameters： ０ ・・・Master
１ ・・・Slave
Response：Same as parameters
Restrictions： Alarm response is returned for normal SET commands in the following conditions.
・If analog option is not attached (ZX-S Series which A is not attached to the end of name)
・While operating as a series operation slave unit.
・While operating as a parallel operation slave unit.
・ Sequence operation in progress
＜Ex.＞
SYST：SER 0
SYST：SER？
0
When changing from Master to Slave with this command, the device address will be forced to change
from 1 to 2. From this, the device will be unable to directly communicate with the PC from that point.
Caution
