Parameter
Description
Unit
Direction of rotation
The tool travels in the programmed direction from the circle starting point to its end
point. You can program this direction as clockwise (right) or counter-clockwise (left).
Clockwise direction of rotation
Counter-clockwise direction of rotation
Polar angle to the pole, end point (abs) or
change in polar angle to the pole, end point (inc)
Degrees
F
Machining feedrate
mm/rev
mm/min
mm/tooth
10.7.15
Obstacle
Function
If there is an obstacle between 2 position patterns, it can be crossed. The height of the obstacle
is programmed in absolute terms.
If all positions in the 1st pattern have been machined, the tool axis travels with rapid traverse
to a height corresponding to the obstacle safety clearance. The new position is
approached with rapid traverse at this height. The tool axis then approaches a position
according to Z0 of the position p safety clearance with rapid traverse.
Procedure
1.
The ShopMill program to be edited has been created and you are in the
editor.
2.
Press the "Drilling" softkey.
3.
Press the "Positions" and "Obstacle" softkeys.
The "obstacle" input window opens.
Note
Obstacles are only taken into consideration if they lie between 2 position patterns. If the tool
change point and the programmed retraction plane are positioned below the obstacle, the tool
travels to the retraction plane height and on to the new position without taking the obstacle
into account. The obstacle must not be higher than the retraction plane.
Programming technological functions (cycles)
10.7 Additional cycles and functions in ShopMill
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
669
