20.4
Setting-up events
In the "Send SMS for the following events" area, select the events using the check box, which
when they occur, an SMS is sent to the user.
● Programmed messages from the part program (MSG)
In the part program, program an MSG command via which you receive an SMS.
Example: MSG ("SMS: An SMS from a part program")
● Select the following events using the <SELECT> key
– The workpiece counter reaches the following value
An SMS is sent if the workpiece counter reaches the set value.
– The following program progress is reached (percent)
An SMS is sent if, when executing a part program, the set progress is reached.
– Actual NC program reaches runtime (minutes)
An SMS is sent after the set runtime has been reached when executing an NC program.
– Tool usage time reaches the following value (minutes)
An SMS is sent if the usage time of the tool reaches the set time when executing a part
program (derived from $AC_CUTTING_TIME).
● Messages/alarms from the Tool Manager
An SMS is sent if messages or alarms are output to the Tool Manager.
● Measuring cycle messages for tools
An SMS is sent if measuring cycle messages are output that involve tools.
● Measuring cycle messages for workpieces
An SMS is sent if measuring cycle messages are output that involve workpieces.
● Sinumerik messages/alarms (error when executing)
An SMS is sent if NCK alarms or messages are output that cause the machine to come to
a standstill.
● Machine faults
An SMS is sent if PLC alarms or messages are output that cause the machine to come to
a standstill (i.e. PLC alarms with an Emergency Stop response).
● Maintenance intervals
An SMS is sent if the service planner registers pending maintenance work.
● Additional alarm numbers:
Here, specify additional alarms where you should be notified if they occur.
You can enter individual alarms, several alarms or alarm number ranges.
Examples:
1234,400
1000-2000
100,200-300
Requirement
● The "User profiles" window is opened.
● You selected the event "Measuring cycle messages for tools", "Measuring cycle messages
for workpieces", "Sinumerik messages/alarms (errors when executing)", "Machine faults"
or "Maintenance intervals".
Easy Message (828D only)
20.4 Setting-up events
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
885
