Parameter
Description
Unit
X0
Reference point X from thread table ∅ (abs)
mm
Z0
Reference point Z (abs)
mm
P0
Thread pitch 1
mm
X1 or
X1α
● Intermediate point 1 X ∅ (abs) or
● Intermediate point 1 in relation to X0 (inc) or
● Thread taper 1
Incremental dimensions: The sign is also evaluated.
mm
Degrees
Z1
● Intermediate point 1 Z (abs) or
● Intermediate point 1 in relation to Z0 (inc)
mm
P1
Thread pitch 2 (unit as parameterized for P0)
mm/rev
in/rev
turns/"
MODULUS
X2 or
X2α
● Intermediate point 2 X ∅ (abs) or
● Intermediate point 2 in relation to X0 (inc) or
● Thread taper 1
Incremental dimensions: The sign is also evaluated
mm
Degrees
Z2
● Intermediate point 2 Z (abs) or
● Intermediate point 2 in relation to Z0 (inc)
mm
P2
Thread pitch 3 (unit as parameterized for P0)
mm/rev
in/rev
turns/"
MODULUS
X3
● End point X ∅ (abs) or
● End point 3 in relation to X2 (inc) or
● Thread taper 3
mm
Degrees
Z3
● End point Z ∅ (abs) or
● End point with reference to Z2 (inc)
mm
LW
Thread advance (inc)
mm
LR
Thread run-out (inc)
mm
H1
Thread depth
mm
DP or
αP
Infeed slope flank (inc) or infeed slope (angle)
mm
Degrees
● Infeed along a flank
● Infeed with alternating flanks
D1 or ND
First infeed depth or number of roughing cuts - (only for ∇ and ∇ + ∇∇∇)
mm
rev
Finishing allowance in X and Z – (only for ∇ and ∇ + ∇∇∇)
mm
NN
Number of noncuts - (only for ∇∇∇ and ∇ + ∇∇∇)
Programming technological functions (cycles)
10.4 Turning - milling/turning machine
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
569
