Parameter
Description
Unit
X0
Y0
Z0
The positions refer to the reference point:
Reference point X – (for single position only)
Reference point Y – (for single position only)
Reference point Z – (single position only and G Code position pattern)
mm
mm
mm
W
Width of spigot
mm
L
Length of spigot
mm
R
Corner radius
mm
α0
Angle of rotation
Degrees
Z1
Spigot depth (abs) or depth relative to Z0 (inc) - (only for ∇ and ∇∇∇)
mm
DZ
Maximum depth infeed - (only for ∇ and ∇∇∇)
mm
UXY
Plane finishing allowance for the length (L) and width (W) of the rectangular spigot.
Smaller rectangular spigot dimensions are obtained by calling the cycle again and pro‐
gramming it with a lower finishing allowance. - (only for ∇ and ∇∇∇)
mm
UZ
Depth finishing allowance (tool axis) - (only for ∇ and ∇∇∇)
mm
W1
Width of blank spigot (important for determining approach position) - (only for ∇ and
∇∇∇)
mm
L1
Length of blank spigot (important for determining approach position) - (only for ∇ and
∇∇∇)
mm
FS
Chamfer width for chamfering - (for chamfering only)
mm
ZFS
Insertion depth of tool tip (abs or inc) - (for chamfering only)
mm
* Unit of feedrate as programmed before the cycle call
Parameters in the "Input simple" mode
G code program parameters
ShopMill program parameters
Input
● simple
Milling direction
T
Tool name
RP
Retraction plane
mm
D
Cutting edge number
F
Feedrate
*
F
Feedrate
mm/min
mm/rev
S / V
Spindle speed or constant
cutting rate
rpm
m/min
Programming technological functions (cycles)
10.2 Milling
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
439
