13.5
Tool list
All parameters and functions that are required to create and set up the tools are displayed in
the tool list.
Each tool is uniquely identified by the tool identifier and the sister tool number.
Tool parameters
Column heading
Meaning
Location
BS
* If activated in magazine
selection
Magazine/location number
● The magazine location numbers
The magazine number is specified first, followed by the location number
in the magazine.
If there is only one magazine, only the location number is displayed.
● Load position in the load magazine
The following icons can also be displayed for other magazine types (e.g.
for a chain):
● Spindle location as an icon
● Locations for gripper 1 and gripper 2 (applies only when a spindle with
dual gripper is used) as icons.
Type
Tool type
Specific tool offset data is displayed depending on the tool type (represen‐
ted as an icon).
For milling/turning machines, the icon identifies the position of the tool; this
was selected when the tool was created.
You have the option of changing the tool type or the tool position using the
<SELECT> key.
Tool name
The tool is identified by the name and the sister tool number. You may enter
the names as text or numbers.
Note: The maximum length of tool names is 31 ASCII characters. The num‐
ber of characters is reduced for Asian characters or Unicode characters.
The following special characters are not permitted: | # ".
ST
Sister tool number (for sister tool strategy)
D
Cutting edge number
Length X, length Y, length
Z
Tool length
Geometry length length X, length Y, length Z
Radius
Tool radius
∅
Tool diameter
Tool management
13.5 Tool list
Milling
698
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
