Raymarine LIGHTHOUSE 4, Operation Instructions Manual

Page: 420 / 504

5 [Flight data]
Distance, Speed and Height data is displayed onscreen.
Note:
Displayed Flight data is specific to the UAV app and cannot be
edited.
6 [Controls]
Provides access to the onscreen virtual joystick controls.
7
[Status area]
The status area provides the:
• signal strength of the UAV’s GNSS (GPS) position fix.
• signal strength from remote controller to UAV.
• battery charge state.
• flight time remaining.
• identification of restricted no fly zones.
8 [Virtual joystick]
Provides [Up] , [Down] , [Turn left] and [Turn right] controls.
9 [Virtual joystick]
Provides [Forward] , [Backward] , [Move left] and [Move right]
controls.
Note:
• The UAV app is not available on eS Series and gS Series MFDs.
• On an Axiom XL MFD the UAV connects to the same connection as
a remote card reader. Therefore, on a standalone Axiom XL MFD
installation, electronic cartography, via a chart card, will NOT be available
at the same time as a connection to your UAV. Only pre-loaded world
basemaps will be available in the Chart application.
Compatible UAVs
Currently the UAVs listed below are supported:
• Mavic Pro by DJI
• Mavic Pro Platinum by DJI
• Mavic 2 Pro by DJI
• Mavic 2 Zoom by DJI
Connection to any other UAV is not approved and is performed at your own
risk.
UAV sport mode
When your UAV is in Sport mode (S-Mode), control via your MFD is limited.
In Sport mode the following MFD controls are disabled [virtual joystick] ,
[Gimbal pitch control] , [Take off] , [Return to boat] and [Fish on] / [Circle me] .
UAV app settings menu
You should check and configure the settings listed in the Advanced settings
menu before attempting to operate your UAV.
Advanced
Settings Description
[Initial height after
take-off:] Specifies the height at which the UAV will
hover once it has taken off.
[Minimum safe height
during UAV goto:] Specifies the minimum safe height of the UAV
when performing a Goto.
[Action if remote control
signal is lost:] If your UAV loses connection to the remote
controller then you can select whether your
UAV
[Hover] s in its current location or performs
a [Return to boat] .
[Minimum height:] Specifies the minimum height of the UAV when
performing a Return to boat.
[Return distance:] Specifies the distance from your vessel the
UAV will reach when performing a Return to
boat.
[Height:] Specifies the initial height of the UAV when
performing a Fish on / Circle me.
[Distance:] Specifies the initial distance from your vessel
when performing a Fish on / Circle me.
420