Panasonic LP-GS Series, Serial Communication Command Manual

Page: 160 / 180

160
ERROR
CODE
Description Measures *1
E672
The settings for separator height ratio or row
height ratio are too small.
• Correct the separator height ratio or the barcode
height ratio so that the height is larger than the “line
width (calculation value)” specified in the object
group settings.
• If you want to remove the separator, set 0 to the
separator height ratio.
E673
Cannot create bar code due to the invalid
number of characters for EAN/UPC/JAN code or
GS1 DataBar.
Enter the prescribed number of characters according
to the code type.
E674 The string containing “%” is not properly set.
• If the functional characters such as a counter and
date/time are input, delete and re-enter characters
after “%”.
• To enter “%” as a character to mark, enter “%%”.
• To enter “+” or “/” as a character to mark after the
counter, enter “%+” or “%/”.
E678
The string No. specified by the SIN command is
not acceptable because the No. has not been set
in Laser Marker NAVI smart. Specify the same No. set in “characters specified by
SIN command” setting in Laser Marker NAVI smart
to the string No. in SIN command data.
E679 *2, *3
Communication was interrupted. The adjustment
value of power optimization by marking position
could not apply to the laser marker.
• Set the adjustment value of power optimization by
marking position and apply it to the laser marker
again.
• Do not turn off the power during the application
processing.
• Do not turn on the remote mode during the
application processing.
E680
Any of the following functions that are not
available with the RUN mode ON are configured.
• Registered characters via I/O
• External offset (via I/O and SEO command)
• Characters specified by SIN command
• Link control with external image checkers
• To execute marking in the RUN mode, delete
these functions from the marking data.
• When you use these functions, control the laser
marker in the remote mode.
E682 *3, *4
Any of the following functions that are not
available with on-the-fly marking are configured.
• Link control with external image checkers
• Overwriting interval
• Skip marking of 2D code (module marking
order)
When the trigger mode is set to Marking at
regular intervals or Multiple triggers, those
functions are also not available.
• Registered characters via I/O
• External offset (via I/O and SEO command)
• Characters specified by SIN command
• Counter reset at date change
• To use on-the-fly marking, delete these functions
from the marking file.
• Some functions are available when Trigger mode
of the on-the-fly settings is set to Single trigger.
ME-LP-GS-SR-COMP-3