Panasonic LP-GS Series, Serial Communication Command Manual

Page: 80 / 180

80
⿎ Example of command settings
Condition: Counter No. = 0, Current value = 1234, Starting value = 0, End value = 9999, Step value = 1,
Count timing = 8, Reset at date change = 1
• Setting
Transmission data [STX] CNT S 000123400000000999900000181 [CR]
• Readout
Transmission data [STX] CNT R 0 [CR]
Response data [STX] CNT A 000123400000000999900000181 [CR]
ンㄆㄇㄆㄓㄆㄏ㄄ㄆ
• If the counter is reset at date change during on-the-fly marking operation (single trigger mode), the marking trigger ready
status turns off momentary and there is a case that the next marking could not be executed due to Warning E751.
• With LP-400/V compatible command mode, the counter numbers 4 to 15 and global counter numbers 20 to 31 cannot be
set and readout.
• With LP-400/V compatible command mode, the counter value larger than 999999 cannot be set and readout.
3-6-2 Counter reset: CTR
Resets the current value to the starting value.
⿎ Setting request data
Start
code
CTR S
[Counter 0] [Counter 1] [Counter 2] [Counter 3]
[Global counter 16] [Global counter 17]
[Global counter 18] [Global counter 19]
8-byte
(Check
sum)
End code
⿎
Data description
Name
Data length
[byte]
Data contents Remarks
Counter 0 1
“0”: Do not reset
“1”: Reset
Counter 1 1
Counter 2 1
Counter 3 1
Global counter 16 1
Global counter 17 1
Global counter 18 1
Global counter 19 1
Total data length 8 The data length is fixed.
ンㄆㄇㄆㄓㄆㄏ㄄ㄆ
• The setting changed by this command is saved in the laser marker without overwriting to the file.
• If the counter is reset during on-the-fly marking operation, the marking trigger ready status turns off momentary and
there is a case that the next marking could not be executed due to Warning E751.
• With LP-400/V compatible command mode, the counter numbers 4 to 15 and global counter numbers 20 to 31 cannot be
reset.
⿎ Example of command settings
Condition: To reset counter 0 and 16
• Setting
Transmission data [STX] CTR S 10001000 [CR]
ME-LP-GS-SR-COMP-3