Panasonic LP-GS Series, Serial Communication Command Manual

Page: 93 / 180

93
2. When the code type is CODE128 and EAN/UPC/JAN
Name
(> Name in LP-400/V)
Data length
[byte]
Data contents Remarks
Object No.
(> Bar code No.)
1 “0”–“7”: Object No. 1100 to 1107
System reserved value
(Area No.)
1 “0”–“9”, “A”–“F”
This value does not affect the
settings anymore.
Code type 2
“02”: CODE128 without human readable text
“04”: EAN/UPC/JAN without human readable text
“08”: EAN/UPC/JAN with human readable text
“09”: CODE128 with human readable text
Invert 1
“0”: Do not invert
“1”: Invert Set “0” to mark a bar, “1” to
mark a space.
System reserved value 1 “1” or “0”
This value does not affect the
settings anymore.
The response data for readout
is always “1”.
Bar code height 7
Model Setting range [mm]
LP-GS051(-L) “000.050”–“055.000”
LP-GS052 “000.050”–“030.000”
LP-RC350S “000.050”–“085.000”
LP-RF200P
LP-RV200P
“000.050”–“090.000”
Narrow element width 5 “0.050”–“1.000” [mm]
Specify a larger value than
the line width in the object
group settings.
X-position 8
“-999.999”–“+999.999” [mm]
It is the center coordinate of
the code.
Y-position 8
Rotation angle 7 “-180.00”–“+180.00” [°]
The rotation center is the
center of the code symbol.
Quiet/narrow ratio 4 “00.0”–“20.0”
Ratio of the quiet zone width
to narrow element width.
System reserved value
(> Double width/narrow
element)
3 “1.4”–“2.6”
• These values do not affect
the settings anymore.
• The readout values are
always “2.0”, “3.0” and “4.0”
respectively regardless the
settings.
System reserved value
(> Triple width/narrow
element)
3 “2.1”–“3.9”
System reserved value
(> Quadruple width/
narrow element)
3 “2.8”–“5.2”
Laser power correction 3 “000”–“999” [%]
The correction ratio is
calculated using the value set
at the laser settings as 100%.
Scan speed correction 3 “001”–“999” [%]
Pulse cycle correction * (3) “001”–“999” [%]
Total data length
60
or
63
The data length is fixed.
• LP-GS/LP-RC series: 60-byte
• LP-RF/LP-RV series: 63-byte
* Only for LP-RF series and LP-RV series.
ンㄆㄇㄆㄓㄆㄏ㄄ㄆ
• With LP-400/V compatible command mode, “Code marking direction” cannot be set. To this item the setting by Laser
Marker NAVI smart or the initial value if it was not set, is applied.
ME-LP-GS-SR-COMP-3