Panasonic LP-GS Series, Serial Communication Command Manual

Page: 132 / 180

132
3-12-5 Line width / filling line spacing: WDC
Sets the line width necessary to avoid crossing at marking intersection and the filling line spacing for bold characters and
bar codes.
ンㄆㄇㄆㄓㄆㄏ㄄ㄆ
• Settings by this command are applied to the object group No. 1000. To the object group No. 1000 the marking data
converted from LP-400/V files and the data set by LP-400/V compatible command mode belong.
⿎ Setting request data / response data for readout
Start
code
WDC
Sub
command
[Line width] [Filling line spacing]
10-byte
(Check
sum)
End code
Sub command is “S” for the setting request data and “A” for the response data for readout.
⿎ Readout request data
Start
code
WDC R
(Check
sum)
End code
⿎ Data description
Name
Data length
[byte]
Data contents Remarks
Line width 5 “0.010”–“2.000” [mm]
It is the segment width for the purpose of
calculation.
Applies to the value of the width for creating the
clearance at the intersection of lines comprising
characters.
Filling line spacing 5 “0.010”–“2.000” [mm]
• This setting is applied to both “bold filling line
spacing” and “bar code filling line spacing”.
• In the response data for readout this value
represents the bold filling line spacing.
• The bar code filling line spacing specifies the
spacing of the marking lines for bar codes and
PDF417 modules.
Total data length 10 Fixed length.
⿎ Example of command settings
Condition: Line width = 0.2, Filling line spacing = 0.1
• Setting
Transmission data [STX] WDC S 0.2000.100 [CR]
• Readout
Transmission data [STX] WDC R [CR]
Response data [STX] WDC A 0.2000.100 [CR]
ME-LP-GS-SR-COMP-3