Panasonic LP-GS Series, Serial Communication Command Manual

Page: 124 / 180

124
⿎ Example of command settings
Condition: Moving direction = 2, Line speed control = 1, Trigger mode = 0
• Setting
Transmission data [STX] TRG S 210 [CR]
• Readout
Transmission data [STX] TRG R [CR]
Response data [STX] TRG A 210 [CR]
3-11-2 Encoder resolution: ENC
Supported model: LP-RC series / LP-RF series / LP-RV series
Sets the encoder resolution value used for the on-the-fly marking. This setting is applied to all marking files.
⿎ Setting request data / response data for readout
Start
code
ENC
Sub
command
[Encoder resolution]
6-byte
(Check
sum)
End code
Sub command is “S” for the setting request data and “A” for the response data for readout.
⿎ Readout request data
Start
code
ENC R (Check sum) End code
⿎ Data description
Name
Data length
[byte]
Data contents Remarks
Encoder resolution 6 “005.00”–“600.00” [pulses/mm]
Only when line speed control is set to
“encoder input”, set this value.
Total data length 6 Fixed length.
ンㄆㄇㄆㄓㄆㄏ㄄ㄆ
• The setting changed by this command is saved in the laser marker without overwriting to the file.
⿎ Example of command settings
Condition: Encoder resolution = 120.5
• Setting
Transmission data [STX] ENC S 120.50 [CR]
• Readout
Transmission data [STX] ENC R [CR]
Response data [STX] ENC A 120.50 [CR]
ME-LP-GS-SR-COMP-3