Panasonic LP-GS Series, Serial Communication Command Manual

Page: 75 / 180

75
Name
(> Name in LP-400/V)
Data length
[byte]
Data contents Remarks
Horizontal and
vertical alignment
1
“0”: Left and first baseline
“1”: Center and first baseline
“2”: Right and first baseline
• Specifies which point in the
character strings is the origin for the
character object.
• With LP-400/V compatible
command mode, the vertical
alignment is always set to “first
baseline”.
Character height 7
Model Setting range [mm]
LP-GS051(-L)
“000.100”–“055.000”
LP-GS052
“000.060”–“030.000”
LP-RC350S “000.100”–“085.000”
LP-RF200P
LP-RV200P
“000.100”–“090.000”
To make the characters bold, set the
ratio of the character height and width
not to be other than the range from
1/10 to 10.
Character width 7
X-position 8
“-999.999”–“+999.999” [mm]
Specifies the origin coordinate of
character strings.
Y-position 8
Character spacing or
Character string
width
7
Model Setting range [mm]
LP-GS051(-L) “000.000”–“055.000”
LP-GS052 “000.000”–“030.000”
LP-RC350S “000.000”–“085.000”
LP-RF200P
LP-RV200P
“000.000”–“090.000”
Specifies a character spacing for fixed
spacing/proportional, and a character
string width for justify.
Linefeed spacing 7
Rotation angle 7 “-180.00”–“+180.00” [°]
The rotation center is the origin of the
character strings.
Font No. 1 “1”–“9”
With LP-400/V compatible command
mode, the fonts from No. 10 cannot be
set and readout.
Bold line width 5 “0.000”–“6.000” [mm]
• If you do not make characters bold,
set 0.000.
• If you make characters bold, set the
bold line width to 1/2 or less of the
character height or width, whichever
is smaller.
Laser power
correction
3 “000”–“999” [%]
The correction ratio is calculated using
the value set at the laser settings as
100%.
Scan speed
correction
3 “001”–“999” [%]
Pulse cycle
correction *
(3) “001”–“999” [%]
Total data length
72
or
75
The data length is fixed.
• LP-GS/LP-RC series: 72-byte
• LP-RF/LP-RV series: 75-byte
* Only for LP-RF series and LP-RV series.
ME-LP-GS-SR-COMP-3