Panasonic LP-GS Series, Serial Communication Command Manual

Page: 112 / 180

112
3-9-2 Point radiation correction: PRF
Specifies the offset value of the position and laser power to the all points set in the selected object no.
⿎
Setting request data / response data for readout
Start
code
PRF
Sub
command
[Object. No.] [System reserved value]
[X-offset] [Y-offset] [Laser power correction]
[Pulse cycle correction]
LP-GS / LP-RC: 22-byte
LP-RF / LP-RV: 25-byte
(Check
sum)
End code
Sub command is “S” for the setting request data and “A” for the response data for readout.
⿎ Readout request data
Start
code
PRF R
[Object No.]
2-byte
(Check
sum)
End code
⿎ Data description
Name
(> Name in LP-400/V)
Data length
[byte]
Data content Remarks
Object No.
(> Point radiation No.)
2 “00”–“15”: Object No. 1400 to 1415
System reserved value 1 “0”
X-offset 8
“-999.999”–“+999.999” [mm]
Moves the all points set in the selected
object no. from currently set position.
Y-offset 8
Laser power correction 3 “000”–“999” [%]
• The correction ratio is calculated
using the value of laser power for
each point as 100%.
• When laser power correction ratio
is set to “000”, all points set in the
specified point radiation no. are not
scanned at lasing.
Pulse cycle correction * (3) “001”–“999” [%]
The correction ratio is calculated using
the value set at the laser settings as
100%.
Total data length
22
or
25
Fixed length.
• LP-GS / LP-RC series: 22-byte
• LP-RF / LP-RV series: 25-byte
* Only for LP-RF series and LP-RV series.
⿎ Data example
Condition: Object No. = 1, System reserved value = 0, X-offset = 0, Y-offset = -5.6, Laser power correction = 130,
Pulse cycle correction = 100
• Setting
Transmission data [STX] PRF S 010+000.000-005.600130100 [CR]
• Readout
Transmission data [STX] PRF R 01 [CR]
Response data [STX] PRF A 010+000.000-005.600130100 [CR]
ME-LP-GS-SR-COMP-3