Panasonic LP-GS Series, Serial Communication Command Manual

Page: 78 / 180

78
3-5-5 Character object settings (shortened): SPC
Sets only X-/Y-position and laser power correction in the character object settings.
ンㄆㄇㄆㄓㄆㄏ㄄ㄆ
• You can use this command as a shortened command consisting only of X-/Y-positions and laser power correction of the
character object settings (STC) command.
• This command is applied to the character objects (reference list type).
⿎ Setting request data / response data for readout
Start
code
SPC
Sub
command
[Object No.] [X-position] [Y-position]
[Laser power correction]
21-byte
(Check
sum)
End code
Sub command is “S” for the setting request data and “A” for the response data for readout.
⿎ Readout request data
Start
code
SPC R
[Object No.]
2-byte
(Check
sum)
End code
⿎ Data description
Name
(> Name in LP-400/V)
Data length
[byte]
Data contents Remarks
Object No.
(> Character condition No.)
2
“01”–“60”: Object No. 1001 to
1060
X-position 8
“-999.999”–“+999.999” [mm]
Specifies the origin coordinate of
character strings.
Y-position 8
Laser power correction 3 “000”–“999” [%]
The correction ratio is calculated using
the value set at the laser settings as
100%.
Total data length 21 Fixed length.
⿎ Example of command settings
Condition: Object No. = 01, X-position = 15, Y-position = -10, Laser power correction = 80
• Setting
Transmission data [STX] SPC S 01+015.000-010.000080 [CR]
• Readout
Transmission data [STX] SPC R 01 [CR]
Response data [STX] SPC A 01+015.000-010.000080 [CR]
ME-LP-GS-SR-COMP-3