62
Preparing Flat Connectors
Section 3-3
3.
After attaching the cable, confirm that it is properly pressure-welded as
shown below.
Preparing DCN5-BR4 Flat Connector Plugs
Component Names
■
Cutting the Cable
Cut the cable perpendicular to the length.
To prevent short-circuits, cut the cable with a sharp blade, such as wire cut-
ters, and be sure that there are no whiskers on the wires.
■
Attaching the Cable
1,2,3...
1.
As shown in the diagram below, place the cable so that the white line is in
the direction of the side with the open cover, with the white line on the cable
facing upward.
Be sure there are no gaps here.
Be sure that the connector is locked.
Cover
White line
(Side with cover open)
From the left: red, white, blue, and black
Summary of Contents for CRT1 - 10-2008
