Omron CRT1 - 10-2008, Operation Manual

Page: 361 / 584

338
Temperature Input Units Section 7-5
Note If the settings are incorrect, the MS Indicator will flash red and the
Unit will not operate. In this case, make the settings again and reset
the power supply.
CRT1-TS04P
Note If the settings are incorrect, the MS Indicator will flash red and the
Unit will not operate. In this case, make the settings again and reset
the power supply.
Note 1. Always set pin 5 and pin 7 to OFF (default).
2. Always set pin 8 to ON if the DIP switch is used to set the ranges. If this pin
is OFF, the DIP switch settings will not be enabled.
3.
The DIP switch settings are read when the power is turned ON.
4.
°
C/
°
F display settings cannot be set individually for each input.
Setting Using the CX-
Integrator Input types can be set for each temperature input using the CX-Integrator.
Use the following procedure.
1,2,3... 1. Turn ON the power supply to the Temperature Input Unit.
2. Double-click the icon of the Temperature Input Unit to be set in the Network
Configuration Window or right-click the icon and select
Parameter - Edit .
The Configuration Window will be displayed.
3. Click the tab for the input where the input type is to be set and select an
input type in the
Input Type Field.
OFF ON OFF ON U
ON ON OFF ON N
OFF OFF ON ON W
ON OFF ON ON B
OFF ON ON ON PL2
ON ON ON ON Not used.
SW1 SW2 SW3 SW4 Input type
Always
OFF OFF Always OFF. PT100 (
−
200 to 850
°
C)
ON PT100 (
−
200 to 200
°
C)
SW1 SW2 SW3 SW4 Input type