92
Connecting External I/O for Slave Units
Section 3-6
4.
Lightly pull the wire to confirm that it is connected properly.
Note
To remove a wire, push in the operation lever, check that the operation lever
has locked, and then pull out the wire. After removing the wire, always return
the operation lever to its normal position.
3-6-3
Connecting to MIL Connector Terminals
Use any of the following methods to connect to a MIL connector.
• Use an OMRON MIL Cable.
• Pressure-weld a Flat Cable to a MIL Socket.
• Pressure-weld a loose-wire cable to a MIL connector.
Using OMRON MIL
Cable
• Connecting Relay Terminals
The MIL Cables for connecting OMRON Relay Terminals are shown in the
following table. Select the appropriate Cable depending on the combina-
tion of Remote I/O Terminals and Relay Terminals that are used.
Reset opening
Operation lever
(white)
Slave model
MIL Cable model
Connected Relay
Terminal
Remarks
CRT1-VID16ML
G79-I
@
C
G7TC-ID16
G7TC-IA16
---
CRT1-VOD16ML
G79-O
@
C
G7TC-OC16/OC08
G7OD-SOC16/VSOC16
G7OD-FOM16/VFOM16
G7OA-ZOC16-3
G7OD-SOC08
G7OR-SOC08
---
Summary of Contents for CRT1 - 10-2008
