55
Preparing Flat Connectors
Section 3-3
(3) Set the connector in the correct orientation.
3.
After attaching the cable, confirm that it is properly pressure-welded as
shown below.
3-3-2
Flat Cable I
Preparing DCN4-TR4 Flat Connector Sockets
Component Names
■
Cutting the Cable (when Extending Cable or Connecting a Terminating
Resistor)
Cut the cable perpendicular to the length.
To prevent short-circuits, cut the cable with a sharp blade, such as wire cut-
ters, and be sure that there are no whiskers on the wires.
OK
NG
NG
Be sure the connector is locked
on both the left and right sides.
Be sure there are no gaps here.
Cover
Housing
Cable confirmation slot
Cable labels
(Flat cable: black, blue, white, and red)
Black
Summary of Contents for CRT1 - 10-2008
