46
Installing Slave Units
Section 3-1
2.
Hook the bottom of the End Plate on the DIN Track first, and then the top.
Attach an End Plate on each side of the Unit, and tighten the screws to se-
cure them. Check to make sure that the Unit is firmly secured.
3-1-4
Mounting with a Mounting Bracket
Slave Units with e-CON connectors (CRT1-V
@
D08S(-1)) or MIL connectors
(CRT1-V
@
D
@@
ML(-1)) can be panel-mounted or wall-mounted, either verti-
cally or horizontally, using special Mounting Brackets.
Required Brackets
Dimensions
CRT1-ATT01
DIN Track
DIN Track mounting pin
End Plate
Name
Model
Applicable Slave Unit
Mounting Bracket
CRT1-ATT01
Units with MIL Connectors
CRT1-V
@
D16ML(-1)
CRT1-ATT02
Units with e-CON Connectors
CRT1-V
@
D08S(-1)
SRT2-ATT02
Units with MIL Connectors
CRT1-V
@
D32ML(-1)
18.7
35
(mm)
13
Mounting Hole Dimensions
Two, 3.2 dia. or M3
16±0.2
Summary of Contents for CRT1 - 10-2008
