333
Monitoring Temperature Data
Section 7-4
Note
Always update the information when the parameters have been edited or set.
Item
Description
Monitor
Display
Input Type
Displays the present input sensor type.
Display Mode
Indicates the number of digits displayed.
0000: No decimal point
0000.0: One digit below the decimal point
0000.0: Two digits below the decimal point
I/O Comment
Displays the text set as the connected device
comment.
Last Mainte-
nance Date
Displays the last maintenance date that was set.
Present Value
Displays the present temperature input value.
Peak Value
Display the peak value, bottom value, top value,
and valley value of the temperature data retained
by the Unit.
Bottom Value
Top Value
Valley Value
Rate of Change
Displays the rate of change in comparison to the
previous sampling cycle.
Temperature
Total Time
Displays the total time the temperature has been
within the set temperature range.
Top/Valley Count
Displays the count measured by the Top/Valley
Count Function.
Cumulative
Counter
Displays the total time calculated by the cumula-
tive counter.
Max Value
Displays the maximum and minimum values of
the temperature data retained in the Unit.
Min Value
Status
check
boxes
Over Range
Selected when the temperature data is above the
displayable range.
High Alarm Over
Selected when the temperature data exceeds the
monitor value set for the comparator function.
High Warning
Over
Low Warning
Over
Low Alarm Over
Under Range
Selected when the temperature data is below the
displayable range.
Broken Wire
Selected when there is a disconnected wire.
Threshold Cumu-
lated Counter
Over
Selected when the cumulated time exceeds the
monitor value set for the Cumulative Temperature
Function.
Cumulative
Counter Overflow
Selected when there is an overflow in the cumu-
lative counter value.
Cumulative
Counter Under-
flow
Selected when there is an underflow in the cumu-
lative counter value.
Temperature
Total Time Over
Selected when the present value in the set tem-
perature range exceeds the monitor value.
Top/Valley Count
Over
Selected when the top or valley count exceeds
the monitor value.
User Adjustment
Selected when the user-set adjustment function
is operating.
Buttons
Clear Buttons
Clear the displayed values
Summary of Contents for CRT1 - 10-2008
