371
Industry Standard Sensor Connectors
Section 9-3
9-3-3
Two-point Input Units (IP54)
CRT1B-ID02SP/CRT1B-ID02SP-1
Input Section Specifications
Note
The current consumption is for Bit Slave Unit communications cur-
rent when all inputs are OFF, i.e., it does not include input device
current consumption. The communications power supply is also
used for the I/O power supply for sensors. Be sure to consider the
sensor current consumption and the number of sensors connected
in addition to the communications power. The power supply current
consumption is expressed by the following formula.
Communications power supply current consumption = Bit Slave
Unit communications current consu (Bit Slave Unit input
current
×
number of inputs used) + (sensor current consumption
×
number of sensors used)
Item
Specification
Model
CRT1B-ID02SP
CRT1B-ID02SP-1
I/O capacity
2 inputs
Internal I/O common
NPN
PNP
ON voltage
10.5 VDC min. (between each
input terminal and the V terminal)
10.5 VDC min. (between each
input terminal and the G terminal)
OFF voltage
5 VDC max. (between each input
terminal and the V terminal)
5 VDC max. (between each input
terminal and the G terminal)
OFF current
1.0 mA max.
Input current
3.0 mA min./input (at 10.5 VDC)
Sensor power supply voltage
Communications power supply voltage 0 V (max.)
Communications power supply voltage
−
1 V (min.)
ON delay
1.5 ms max.
OFF delay
1.5 ms max.
Number of circuits per common
2 inputs/common
Power short-circuit detection
Supported.
Isolation method
No isolation
Input indicators
LEDs (yellow)
Degree of protection
IEC standard IP54
Installation
Screw installation (M4)
Power supply type
Network power supply
Communications power supply
current consumption (See note.)
65 mA max. for 24-VDC power supply voltage
80 mA max. for 14-VDC power supply voltage
Weight
184 g max.
Summary of Contents for CRT1 - 10-2008
