Omron CRT1 - 10-2008, Operation Manual

Page: 73 / 584

50
Connecting Cables Section 3-2
Mounting Bit Slave
Units Using Screw
Brackets
The Bit Slave Units (CRT1B-ID02S(-1) and CRT1B-OD02S(-1)) are installed
using the enclosed screw bracket along with screw holes in one of the two ori-
entations shown below.
Use the following procedure to mount the screw bracket.
1,2,3... 1. Insert the screw bracket into the back of the Bit Slave Unit along the
guides.
2. Press the screw bracket in until the hooks on the bracket are completely
locked into place.
3-2 Connecting Cables
In a CompoNet Network, Units can be connected and cables can be branched
and extended by using Communications Cable and mounting connectors to
Units. The methods for connecting Communications Cables and Units and for
branching depend on the cable type and branching formation used.
The differences are shown in the following table.
Screw brackets
Guides
Screw bracket
Screw bracket hook