Omron CRT1 - 10-2008, Operation Manual

Page: 84 / 584

61
Preparing Flat Connectors Section 3-3
Line Extensions and Terminating Resistor Connections
2. Hold the cable so that it does not move and close the cover.
Note When extending the cable or connecting it to a Terminating Resis-
tor, make sure that the end of the cable is inserted all the way to the
cable stopper so that it will not be pulled out.
■
Pressure-welding the Connector
Use the DWT-A02 Pliers to pressure-weld the connector.
1,2,3... 1. Set the connector on the pressure-welding block of the crimping tool.
As shown below, align the center (see arrows) of the connector cover with
the center of the pressure-welding block on the Pliers.
2. Squeeze firmly on the Pliers until the lock on the connector clicks into
place.
Connector position reference surfaces
Pliers
Connector cover