01/12 Rev. 5.07-01
USER MANUAL
Setup
AP 5.4 – AP 5.6
16
Printhead pressure
Increasing the printhead (contact) pressure increases the blackness of the
printout.
Increasing
the printhead pressure:
Turn each knob [25A] until a
higher
number is placed opposite of the edge
[25B]
Decreasing
the printhead pressure:
Turn each knob [25A] until a
lower
number is placed opposite of the edge
[25B]
[25] Adjusting knob (A) for the printhead contact pressure.
Printhead Support
When printing narrow labels, the printhead can come into direct contact with
the print roller in areas where no material is present. This can cause prelimi-
nary wear and tear on the printhead and can lead to varying printing intensities
between the two label edges.
When using narrow labels, activate the printhead support!
Narrow = material width < printhead width
.
The printhead support setting is indicated by the position of the thumb wheel
[5A]. For wide labels, we recommend the “0” setting.
[26] Thumb wheel (A) for printhead support.
1. For narrow labels, turn the thumb wheel clockwise until the marking [5B]
points to “1”. The printhead is lifted on the outside.
A
A
B
A
B
