06/15 Rev. 6.00-02
USER- / SERVICE MANUAL
Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
34
Batch Mode
•
The printer can print the whole label surface.
•
Dispensing of the label takes place during printing. Printing of the next label
is interrupted until the label is completely dispensed.
•
The output volume is at its maximum level.
The
Batch mode
is optimised for printing and dispensing at high speeds.
Due to this, it is not possible to use all features awaliable in modes
Normal 1:1
or
Real 1:1
. Also consider, that printing data must be available on
time and in sufficient quantity.
The following Job/Parameter-combinations must not be used:
•
Jobs with counter fields
•
Jobs with variable fields
•
SYSTEM PARAMETER > Dispensing mode
must be set to "fast".
A graphic can be found under
PRINT PARAMETERS > Cut mode > Batch mode
.
Real 1:1 Mode
(Default setting)
•
The printer can print the whole label surface.
•
After dispensing a label, the beginning of the next label is drawn back under
the print head.
•
The output volume is lower than in
Batch Mode
or
Normal 1:1 Mode
.
A graphic can be found under
PRINT PARAMETERS > Cut mode > Real 1:1 mode
.
Dispenseposition
AP 5.4
AP 5.6
Only with
SYSTEM PARAMETER
> Periph. device
= „Tear-off edge“.
Dispense position
Adjusts the dispense position in or against the feed direction. Depending on
the set dispense position, the dispensed label sticks to the backing paper with
a more or less wide strip [12]. The required width of this strip depends on the
further processing.
[12] Dispense position (= stopp position) of the dispensed label.
x.x mm
Setting range: -30.0 to +20.0 mm; Unit interval: 0.1 mm; Default
setting: -6.0 mm
Dispensed label
Dispense position
Dispensing edge
Backing paper
Z0040E
.cdr
