06/15 Rev. 6.00-02
USER- / SERVICE MANUAL
Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
97
Feed adjust
AP 5.4
AP 5.6
Corrects the material feed length. Such a correction can be necessary when
printing on very long labels, to compensate slippage-related feeding inaccu-
racy.
For application instructions, refer to the Service Manual, topic section
„Electronics Gen. 3“, chapter
Adjusting the imprint position
.
x.x% [ribbon]
Setting for
thermal transfer printing
Setting range: -10.0 to +10.0; Step width: 0.1%; Default setting: 0%
Only appears if thermal transfer printing was selected (see
SYSTEM
PARAMETER > Ribbon autoecon.
)
x.x% [direct]
Setting for
thermal direct printing
Setting range: -10.0 to +10.0; Step width: 0.1%; Default setting: 0%
Only appears if thermal direct printing was selected (see
SYSTEM
PARAMETER > Ribbon autoecon.
)
Punch y calibr.
AP 5.4
AP 5.6
Only in production mode
Compensating the variation of distance between punch sensor and thermal
bar of the printhead.
x.x mm
Setting range: -3.0 to 3.0; Default setting: 0.0; Unit interval: 0.1
Memory card test
AP 5.4
AP 5.6
Pressing the online button starts a test routine for the Compact Flash Card
memory. The following display shows up after successful testing:
If the memory card is defective or not available, a corresponding error report
shows up.
For test purposes, the printer creates a file named TESTXXXX.TXT in the
root directory of the card. An already existing file with this name will be over-
written.
Memory card test
Card Test O.K.
