06/15 Rev. 6.01-01
USER MANUAL
Commissioning and Operation
AP5.4 – AP5.6
6
Connecting the printer
[7] Rear side of AP 5.6.
1. Make sure that the printer is switched off (mains switch [7C] at “0” position).
2. Connect the mains cable [7A] to the mains connector at the printer.
3. Connect the mains cable into a mains socket.
4. Connect the printer and computer or printer and network using suitable data cable
(example: USB cable to USB (device) port [7B] of printer and to USB port of host
computers).
5. Turn on the unit using the mains power switch (position “1”).
As soon as the printer is ready, the following appears:
If
SYSTEM PARAMETERS > Turn-on mode
is set to “Online”, the printer switches di-
rectly into online mode after turning on the printer!
WARNING!
This unit operates at mains voltage! Contacting electrically live components can
cause potentially lethal electrical shocks and burns.
Make sure that the machine has been switched off before connecting the mains
cable.
Only operate the printer at the mains voltage given on the type plate.
Only connect the printer to a properly installed mains socket with protective
earth.
When installing the mains cable, ensure the following:
a) Nobody can stumble over the cable
b) Mains plug can be pulled in case of emergency
In case of danger, the printer can only be disconnected from the power supply by
removing the power plug from the power supply.
Make sure that the power supply socket for the printer is readily accessible.
Risk of stumbling over cables.
Lay the power supply cable, data cables and compressed air hoses (if applica-
ble) in a way that nobody can stumble over it.
OFFLINE 0 JOBS
B
A
C
