01/12 Rev. 5.07-01
USER MANUAL
Setup
AP 5.4 – AP 5.6
10
AP 5.4/AP 5.6 Dispenser
1. Inserting the label material, see
Inserting a
label roll
on page 7.
2. Remove the release paper from the labels
to approx. 30 cm away from the end of the
label strip [15].
3. Press the red button [14A] on the dispens-
ing edge to unlock the dispensing roll. Re-
move the dispensing roll [14B]
4. As shown, move the backing paper towards
the rewinder [15A].
5. Fasten the end of the backing paper strip to
the clasp [16A].
The short side of the clasp fits into the
groove [17A].
6. Manually rotate the rewinder in a counter-
clockwise direction until the backing paper
is taut.
7. Reconnect the dispensing roll.
After switching on the printer, the rewinder
slowly rotates until the material ribbon be-
comes taut.
The following error message might appear until
the release paper is taut.
Press the Online key (repeatedly if neces-
sary) to acknowledge the message.
Status 5004
Rewinder mat. tear
[14] Dispenser roll (B) above dispenser edge.
[15] Move the covering paper towards the rewinder (A).
[16] Fasten the covering paper to the rewinder.
[17] Insert the clasp with the short side into the groove (A).
B
A
A
A
A
