06/15 Rev. 6.00-02
USER- / SERVICE MANUAL
Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
62
Thin line emphas
AP 5.4
AP 5.6
Only in production mode
Thin line emphasis. Print emphasis for thin lines in order to get a better print
result.
On
(Default) Print emphasis for thin lines is switched on.
Thin lines in the printout, which run crossways to the printing direction, are
printed approx. 1.5 times wider. This may have the effect, that small white
patches are closed with color (e.g. in the „e“ with very small fonts).
Off
Print emphasis for thin lines is switched off.
Voltage offset
AP 5.4
AP 5.6
The voltage offset increases the head voltage and therefore the head tem-
perature which e.g. was set by Easy Plug command (HV).
xx%
Setting range: 0 to 20%; Unit interval: 1%; Default setting: 0%
Miss. label tol.
AP 5.4
AP 5.6
Missing label tolerance
The maximum search path for gaps which cannot be found can be varied. In
cases of difficult gap detection (i. e. minimum variation in the light transpar-
ency, gap to label), shortening the search path is to be recommended. Label
loss resulting from gaps not being detected can be reduced in this way. Print-
ing does not take place during the search process.
xx
Setting range: 0 to 50; Unit interval: 1
•
Example 0 (Zero label length):
A gap must be found after a printed label otherwise an error message is giv-
en. This setting is for detecting every missing label.
•
Example 5 (Five label lengths):
A gap must be found after a maximum of 5 label lengths otherwise an error
message is given.
Gap detect mode
AP 5.4
AP 5.6
After one of the following events, the printer must always search for the
punch, that is initialize the label material:
•
After switching the printer on
•
After changing the label material
