03/13 Rev. 5.08-01
USER MANUAL
Maintenance and Cleaning
AP 5.4 – AP 5.6
Print Roller
10
Changing the Print Roller
Tool
2,5 mm hex screwdriver (comes with the
printer).
Disassembly:
1. Switch off the printer and disconnect from
the power.
2. Remove material and foil from the printer.
3. Unfasten the screw [11B] in the middle of
the tear-off edge [11A]. Remove the tear-off
edge.
4. Release the set screw [11C].
5. Remove the print roller sideways [12].
Fitting:
1. Push the print roller through the external
bearing plate.
The printer roller axle is flattened on the
end.
2. Place the axle in the socket [12B] and gen-
tly rotate until the flat part [12C] of the axle
is under the set screw.
3. Press the print roller firmly into the socket.
Ball bearing [13B] and bearing plate
[13A] must flush on the inner side!
4. Fasten the set screw.
WARNING!
Risk of burning injuries from a hot
printhead.
Ensure that the printhead has
cooled down before cleaning it.
[11] Print roller at an AP 5.6.
[12] Pull out the print roller (A).
[13] The ball bearing (B) and bearing plate (A) must flush at the inner
side.
A
C
B
A
B
C
A
B
