06/15 Rev. 6.00-02
USER- / SERVICE MANUAL
Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
70
DISPENSER PARA
This menu appears only, if
SYSTEM PARAMETER
> Periph. device
is set to
„Dispenser“.
Dispense Mode
AP 5.4
AP 5.6
Governs the run of the print-dispense procedure.
Only if
SYSTEM PARAMETER > Periph. device
= „Dispenser“.
Normal 1:1 Mode
•
The printer cannot print on the whole label surface. A stripe at the label
beginning stays unprinted.
•
The label is being dispensed while printing.
•
The output volume is at its maximum level.
The width of the unprintable stripe is calculated as follows:
Distance print line to dispensing edge (25 mm) + Dispense position
(tab. 10)
Also refer to parameter
PRINT PARAMETERS > Dispense position
.
A graphic can be found under
PRINT PARAMETERS > Cut mode > Normal 1:1 mode
.
[16] The size of the not imprintable area in Normal 1:1 depends of the setting of parameter
DISPENSE PARAMETERS > Dispense Position
.
Printer
Distance print line - dispensing edge
64-xx
39.8 mm (long dispensing edge)
24.2 mm (short dispensing edge)
AP 5.4
25.0 mm
[10] Distances between print line and dispensing edge for some printers.
a
b
c
Label
Backing paper
Printing
Printhead
Dispensing
Edge
Feed
Direction
Non-printable area with
Dispense
Dispense
a) Dispense position = 0
b)
position < 0
c)
position > 0
Z0137E.ep
s
