01/12 Rev. 5.07-01
USER MANUAL
Setup
AP 5.4 – AP 5.6
14
When the Roll is Empty
End of Material
After the end of the material roll passes by the punch sensor, the following sta-
tus message appears:
Open the pressure lever and pull the end of the material forwards out of the
printer.
End of Ribbon
Once the end of the ribbon has been wound away and the unwinding mandrel
no longer rotates, the following message will appear:
Proceed as described under
Inserting a New Ribbon Roll
on page 12.
End-of-ribbon detection can be shut off when required, e.g. for direct ther-
mal printing:
To do this, set
SYSTEM PARAMETERS > Foil mode
to “Thermal printing”.
For more detailed information on how to set the parameters, see
Info Printouts
and Parameters
.
Status 5002
Material end
Status 5008
Ribbon end
